Stainless steel water pipe Clamp connection mode, Stainless steel pipe In general, there are many connection modes, among which the more common ones are: compression type, compression type, union type, push type, push thread type, socket welding type, welding type, and the derivative combination of traditional connection.

Therefore, it can be selected according to the actual situation, but no matter which one it is, it should be easy to install and firmly and reliably connected. The sealing ring or gasket used in connection should be made of silicone rubber, nitrile rubber, EPDM rubber and other materials.

The connection steps of stainless steel water pipe clamping are as follows:

1. Pipe break: cut the pipe according to the required length to obtain the desired length.

2. Burr removal: remove the burrs on the edge of the pipe to avoid damaging the sealing ring.

3. Marking: marking the insertion length at the pipe end so that the stainless steel pipe can be fully inserted into the fitting socket.

4. Assembly: correctly install the seal ring, Water pipe installation In the U-groove, insert the pipe into the fitting socket.

5. Crimping: Note that the jaw should be vertical to the pipe axis without deviation.

6. Check: After the crimping is completed, use a special gauge to check the crimping size for problems.

How to install stainless steel water pipe clamp connection

1. Piping: It is better to use a cutter for blanking small diameter pipes, and it is better to use a motor driven toothed saw for cutting medium and large diameter pipes. It is prohibited to use a sand pan toothless saw for blanking.

2. Burr removal: Burr removal tools are used on the blanking port surface. Burrs inside and outside the port need to be removed to strictly prevent scratching the seal ring and clean the sharp pipe edges of the port.

3. Mark and draw lines: before the pipe is inserted into the pipe fitting, the insertion depth marking line shall be made on the pipe to prevent the pipe from not being inserted in place for engineering inspection, acceptance and confirmation.

4. Sealing ring inspection: check whether the sealing ring in the pipe fittings is damaged, polluted or misaligned.

5. Pipe interface The depth of the pipe inserted into the socket of the pipe fitting is consistent with the line marking

The adjustment amount shall not be more than 3mm. Please pay attention to ensure the insertion length of the pipe, and do not scratch the inner sealing ring of the pipe fitting.